Hello everybody, this is Corrado if anybody needs help on the Protos or Mini i'll do my best to answer here.

Please write on this thread and not in privat so answer to question can be useful to other users too.

Please write in English, my german is not so good


Corrado

Hi Corrado.
Welcome to our community. Thank you for joining us.

Hi Corrado!

hello Corrado ! ...

Hi Corrado

Wow, that's what I call premium customer support

Question No1:

i´ve little problems with the one-way or rather the bearings.

the one-way fits perfectly on the adaptor, but not the bearings.
i don´t want to mount the bearings with force, so i had to sand the complete adaptor.
I tried a few bearings, all had the same problem.

since we use motors like this... ... i´m afraid, that the one-way gets problems with the smaller diameter of the adaptor.
these motors eliminate bad one-way´s without mercy

hi corrado ... nice to have contact directly...

.. i would like to use my older scorpion 2221-12 on the mini-protos - so i have to cut the motorshaft? correct? any special things to look at, when doing that?

macem

@ Torro, i am not sure i understand your problem.

@Macem, yes you have to cut your motor shaft. When doing it, make sure not to overheat the shaft and pack the motor with a plastic bag so no debris get inside.

Corrado

HighFreq hat geschrieben:@ Torro, i am not sure i understand your problem.

you have the pinion and two bearings for it.
the pinion fits perfectly on the adaptor, the bearings not.
i had to sand the adaptor, to fit the bearings.

Hello Corrado !
Nice to meet you HERE

Please sell the third BB support separately!!!

HighFreq hat geschrieben: ...
@Macem, yes you have to cut your motor shaft. When doing it, make sure not to overheat the shaft and pack the motor with a plastic bag so no debris get inside.

Corrado

ok, thanks a lot ... how long should the shortened, outstanding part of the motorshaft be, to fit into the adaptor? is there any tolerance?

regards, macem

go on msheli.com, there is a manual.

... thanks to flo,

... but i checked the manual already and did not find any reference to the motorshaft...,

regards, macem

hab übersehen, daß Du den Mini meinst